Suzhou Kautas Machinery Co., Ltd
Address：Zhongxing intersection of Gangcheng Avenue, Zhangjiagang City, Jiangsu Province
Contact：Mr Mike Xu
Tel : 0086-13906242281
The energy saving of blow moulding machine can be divided into two parts: one is the power part and the other is the heating part.
Power part energy-saving: Most of the energy-saving way is to save the residual energy of the motor, such as the actual power of the motor is 50Hz, and you actually only need 30Hz to produce, those excess energy consumption will be wasted, the frequency converter is to change the power output of the motor to achieve energy-saving effect.
Energy-saving in heating part: The energy-saving in heating part is mostly energy-saving by electromagnetic heater, and the energy-saving rate is about 30% - 70% of the old resistance coil.
1. Compared with resistance heating, the electromagnetic heater has a layer of insulation layer, which increases the utilization rate of heat energy.
2. Compared with resistance heating, the electromagnetic heater acts directly on the material tube to heat, which reduces the loss of heat transfer energy.
3. Compared with resistance heating, the heating speed of electromagnetic heater is faster than a quarter, which reduces the heating time.
4. Compared with resistance heating, the heating speed of electromagnetic heater is faster, the production efficiency is improved, and the motor is saturated, which reduces the power loss caused by high power and low demand.
The above four points are the reason why the energy-saving of blow moulding machine is as high as 30% - 70% as that of electromagnetic heater.