糖果派对官方网站

Full automatic blow moulding machine

hot key words

contact us

1493252937934201.jpg

Suzhou Kautas Machinery Co., Ltd

Address:Zhongxing intersection of Gangcheng Avenue, Zhangjiagang City, Jiangsu Province 

Contact:Mr Mike Xu      

Tel : 0086-13906242281     

E-mail:

China.kautas@gmail.com




Automatic blow molding machine before the start of the preparation work?

Your current location: Home >> News >> Technology center

Automatic blow molding machine before the start of the preparation work?

Release date:2017-06-26 00:00 source: Click:


What are the main points in the preparation of the automatic blow molding machine and blow molding machine before starting the machine?:

Point 1: the cooling water in the cooler can be turned on.

Second: preheat hydraulic oil. If the temperature of the hydraulic oil in the blow moulding tank is too low, the heater should be turned on immediately.

The third point: press the starting button, then stop immediately, check the direction of the pump running is correct, if found wrong, should immediately change the two-phase induction motor power cord.

The fourth point: the machine should be opened without pressure in the hydraulic system. After opening, adjust the pressure of the overflow system of the pump to the safety pressure. Each of the two units has a pressure release space. After the pump stops, the pressure relief valve must be opened. When the pump is working, the pressure will leak and the valve must close the switch.

The fifth point: adjust all the stroke, rise and shut position.

The sixth point: close the security door. Open the operating side of the security door, according to safety requirements, the machine at work, all safety doors should be closed. Once the safety door is opened, the pump will stop working.

Seventh point: switch on heating and temperature regulation system.

Eighth point: the mold surface must be cleaned and the contact surface with the blow molding machine template must be cleaned before the mold is installed.

Ninth points: the hollow blow molding machine is connected with the master switch of the control cabinet, and the operation switch is adjusted to inching or manual operation.



3.jpg

 


Related tags:Automaticblowmoldingmachine

Recently Viewed:

S
e
r
v
i
c
e
  • service
二维码

Scan QR code

share it
糖果派对官方网站|糖果派对娱乐网站|官方网址版权所有